I found the bracing strut loose inside it. Consulting the Rans build book, it is only pushed into position after the fabric is on & remains wedged in position over a couple of studs. Thus no need to remove much, but it made reassembly much easier with the elevator completely taken off the a/c.
Checking the strut was straight, not bent, and the end cut away was O.K.
I managed. A long stick aided by a bit of masking tape poked through a regular gap in the fabric got it onto the rear stud & lined up. Then with a quick blow from a handy steel rod got it popped back in position.Then fitted the elevator back on & duplicate inspected.
No comments:
Post a Comment